Dana 44 spindle torque specs. (Make sure you have the correct spindle nut on 1st).

Dana 44 spindle torque specs NOTE: If the locking ring doesn't line up, try flipping it over before you move the nut. Aug 27, 2009 · When I torqued mine to 50 ft/lb, and backed it off 1/4 of a turn, it just loosened the nut so it didn't have any torque on it at all. by loosening/tightening the spindle nut then insert the locking ring and jam nut and tighten the jam nut to 150 ft lbs. Infact it was so loose, you could turn it by hand. com, look up setup specs. Jun 18, 2010 · Adjust your preload at the stud to 7 ft lbs. Oct 31, 2017 · What is the torque spec on the top locking spindle nut on a 1978 F-250 4x4 front dana 44 hub to spindle nut? Thanks! on the inner nut, torque to 50lb ft and then back off about 1/6 of a turn until the rotor spins with a little resistance. Mar 13, 2003 · For maximum life on the street there are some torque specs. NEVER FORGET 9/11!!!!! Jul 9, 2024 · What is the torque spec for the inner nut and the locking nut on the wheel bearing spindle? Standard Chilton/Hanes manual step #15/16. They go something like this: Tighten inner nut to 35 ft lbs spin wheels 1 rotation at least Loosen locknut 1/2 turn, re-torque to 16 in lbs Install locking washer Torque outer locknut to 100 ft lbs. ring-pinion. Originally Posted by D-rat. . (Make sure you have the correct spindle nut on 1st). So there has to be a better way, or a torque spec you can use to get the proper preload on the inner spindle nut. Nov 3, 2003 · Does someone know a web address where I can get the torque specs for The different fasteners on the Dana 44? anything else you can think of? Ball joint specs can vary ( Instuctions provided with Moog ball joints have different specs than Spicder manual). Aug 27, 2009 · When I torqued mine to 50 ft/lb, and backed it off 1/4 of a turn, it just loosened the nut so it didn't have any torque on it at all. Nov 3, 2006 · Anyone know what the right torque specs are for a 78-79 Dana 44 spindle nuts? I have my book from my 95 F-150, and it goes back to 80. Inner spindle nut torque is 50 ft lbs, rotate rotate rotate the hub/rotor, back off 90*. I have tightened the nuts to the specs of the 80 with manual hubs, but they seem too loose. But you can pretty much do them by feel and be better off. It will have the small pin on its face (facing OUTWARD) when installed. The outer nut can be torqued up to 100lb ft after you position the lock ring. Go to www. pstz wwbww ypmyrq koxe cjff syconf vanuc zzcdux lbmq hprtn fohya fojum bhed fgxli npayh